ringing a S562 bell by HTTP

2025-11-15 02:14 461 Views [Integration]

Hi,

I have a R20B3 and two S562. The R20B3 has two external buttons connected to IN1+GND and IN2+GND. When pressing the buttons, I see the "Door Status" change from high to low.

I now want to associate an URL action to ring the bell in a remote S562. I tried this :

curl -v -k --ciphers DEFAULT@SECLEVEL=0 -u 'admin:password' 'https://192.168.1.61/api/call?number=FrontDoor&type=door

but I get "403 Forbidden".
Do I need to enable an API in the S562 ?
or any other URL, or method to do this ?
thank you !

Favorites 0

All comments 4

Akuvox_Mia 2025-11-18 16:03:01

Our HTTP commands currently only support activating the relay. Triggering the doorbell is not supported at this time.

0 Reply

cbueche 2025-11-18 16:33:31

is there any other way to have the S562 ring from something else than a SIP call ?

0 Reply

Akuvox_Mia 2025-11-19 15:41:22

cbueche replied at 2025-11-18 16:33
is there any other way to have the S562 ring from something else than a SIP call ?

If the door station and S562 are on the same local area network (LAN), you can enter the IP address on the door station to call the S562. Note that if the SIP hacking function is enabled, you need to add each other as contacts to make normal calls.

0 Reply

cbueche 2025-11-19 17:31:23

great thanks for the tip I'll try!
tip: a full API doc for your devices would be very helpful and avoid these question

0 Reply