Hi Judy, this is an initialization interface when you first open X933H. X933H needs to be worked with Akuvox smart home cloud. before you first boot it, you need to add it to the cloud, then finish this initialization.
1.Creating smart home project needs some basic house and residents and device information. So please confirm the community device mac addresses, number of rooms， unit size， residents name and email before installation.
2.Make sure your distributor has created and sent the installer account to you. And the device mac has been added to Akuvox cloud on the distributor side. (smart home cloud is different from intercom cloud)
3. Enter Akuvox cloud address in your browser and use the installer account to log in.
4. Switch the role as a community manager. create a new community, filling the community necessary information,like community name, remember to enable home automation feature and save it》
5. Click APT Layout. According to the community's layout design to create some layouts. for example， the unit size is 80 feet，in this layout there are 2 beds room, one living room, one dining room and one kitchen.
6. Click the pre-configured layout to add some common home security sensors.
7. Then create some common scenes for the layout. the scenes will help you realize the home automation. for example, you can configure the house light will be turned on automatically in every 6:00pm.
8. After finishing the community common home automation configuration. you can create buildings and apartments information.
9. Filling the residents name and email. or the residents' information can be added by the property after the residents move in. Remember to choose the right layout for the apartment setting. enter the indoor monitor mac address. click save.
10.Finally, please double check the information you have created again.
