Make sure all devices are installed and powered on properly, and on the same local network(LAN).
The building number of door phone A will be 0 by default, installed at the community entrance, which does not require extra configuration for basic calling, unlocking, and monitoring.
If the community only has one building, the building number of door phone B will be 1 by default. You do not need to change this setting.
If there are multiple buildings, you need to set up the building numbers on the device’s screen or its web interface.
On the Device Screen
S532
1. Press *2396#.
2. Press 3 to enter system settings.
3. Press 3 to enter the location settings.
4. Change the building number based on the device location. The value range is 0-9 without DHCP; 0-99 with DHCP.
- Press C to return to the last page, and the setting will not be saved.
- Press # or to save the setting.
R28
1. Press *2396#.
2. Press 3 to enter system settings.
3. Press 3 to enter the location settings.
4. Change the building number based on the device location. The value range is 0-9 without DHCP; 0-99 with DHCP.
- Press C to return to the last page, and the setting will not be saved.
- Press to delete the entered value.
- Press to save the setting.
On the Web Interface
1. Use the device IP to log in to its web interface. The initial username and password are both admin.
2. Click Quick Start and change the building number based on the device location.
Set Indoor Monitors and Door Phones in Apartments
The indoor monitor and door phone installed in each apartment need to be paired up in the solution.
1. Select the device language and time zone on the device's initial setup screen.
2. Tap Next. For the C313W-2, you need to choose the device working mode. Set it to Slave Mode since NS-2 works in Master Mode. If it is not a 2-wire device, simply skip this step.
3. Set the device location and set its device role. If only one indoor monitor is installed in an apartment, designate it as the Master. In this case, it will be the main device where users scan the QR code and register the SmartPlus account. When the device is in Slave mode, select the device number ranging from 1 to 8.
4. Tap Next to set up the network.
5. Tap Next. The indoor monitor will scan the devices on the same LAN as it. At the moment, the door phone will play a “ding” sound, indicating that it is in the pairing mode.
6. Press the push button of the door phone in 5 minutes.
7. Check the door phone and tap Confirm.
When pairing succeeds, “family sent successfully” will display on the device screen.
8. Tap Done to finish the setup.
The indoor monitor will display as a contact on the door phones’ Quick Start > Auto-Discovery Contact List interface.
R20A
S532
Repeat the above steps until indoor monitors and door phones in all rooms are configured.
If you prefer a more visual approach to learning, you can visit the link below, where you’ll find our video tutorials.
Self organizing Network Solution for Community Projects