Access Control

After confirmation: 1.In the action URL: -The userid parameter can only be returned when triggered by 'card swiping, PIN, or face recognition'. -The card_sn parameter can only be returned when 'card swiping (Valid Card Entered/Invalid Card Entered)' is triggered. 2.In the HTTP URL of user's acces ...

This is a file I exported using X912.

Thank you very much for your comments. The solution you propose seems interesting. I understand that it implies a management of RF users directly from Linear WOR for the registration and deregistration of new remotes and (there would not be a unified view of accesses from the AKUVOX register. Tha ...

I noticed that when I dial using speed dial button it briefly says 'invalid number'. The value of the speed dial I'm using is 'demointercom'. Should this be some other format?

A new version is available; you can download it directly by clicking on the link. https://knowledge.akuvox.com/docs/a01-firmware

It should be the same HTTP command as the door stations. Some devices and firmware versions will not provide any success message on the page when you perform the action. There are a few firmwares that it does not seem to work with though.

Maybe try using the Action URL function, depending on unused relays in the door stations you could make it so when Relay B on one of the X912 is triggered it will trigger Relay A on the R29

Please provide a video of the Wiegand wiring and the error prompt "I try to update the Firmware but I always get a Windows message saying: Prohibited Firmware Version!". This will help us determine where the problem lies.

ok thanks

In what scenario do you need this function? We will remove this function soon ~

It is not possible to send multiple different HTTP commands at one time. However, one HTTP command can be sent out when triggering the local relay. Sending commands to A094 and other systems can only be done alternatively.

Very helpful. Thank you!

Hi Akuvox_Mia, Thank you for your response. We need to install an Akuvox or Akuvox-compatible device at the garage entrance to serve as a long-range reader for controlling vehicular access. I'm excited to hear that Akuvox will soon be releasing a UHF device. Best regards.

api relay set Only POST method can be used for this function. Example Request: POST: { "target": "relay", "action": "set", "data" : { "Config.DoorSetting.RELAY.HoldDelayA": "8" } } Example Return: { "retcode": 0, "action": "set", "message": "OK" } ...

@Rachel : In the docs for the R20K the manual see the link attached shows that it should work......but how ? https://knowledge.akuvox.com/docs/led-setting-9 Thanx for your reply and check ! Rgds Sunny

You can refer to this tutorial, where is your button configured on? You should choose the correct relay method https://knowledge.akuvox.com/docs/door-unlock-configuration-21

Unfortunately I haven't heard from your technician yet