Configuration
1.Use the device IP to log in to its web interface. The initial username and password are admin.
2. Go to Device > Display Setting interface. Set Type to Ajax in the desired area.
3. Tap Ajax on the home screen.
4. Enter your Ajax account email and password, then tap Login.
After logging in, you can:
- Switch arming mode.
- Receive notifications from Ajax.
- Check devices.
- Change arming/disarm code.
- Check account information and log out.
Switch Arming Mode
Tap to switch arming mode, which will be synchronized to the Ajax system and the indoor monitor’s built-in arming feature.
- Arm corresponds to Away/Home. Tap Arm, and the indoor monitor will switch to Away, vice versa.
- Tapping Panic sends a panic alarm to both the Ajax App and the indoor monitor. Without dealing with it, the alarm on the indoor monitor will last
for 8 seconds.
- The arming status will be synchronized among multiple indoor monitors in the same room that have the same account logged in.
- Switching arming mode requires entering a code, except when switching from Disarmed to Armed or triggering Panic. The default is 0000.
Switch Space
If multiple spaces are added in the Ajax App, select which space to control.
Select the desired space name in the upper-right corner.
Tap Settings to select the space to synchronize arming/disarming with the indoor monitor.
In the Synchronize Indoor Monitor dropdown, choose the desired space name.
Control Multiple Groups and Relays
When multiple groups are added to a hub, you can arm/disarm a single group or all of them.
- When disarming a group, enter the disarm code.
- When activating Night Mode for all groups, the groups’ arming/disarm status will not change.
- One screen displays up to 3 groups. Tap to turn the page.
You can control multiple relays added to the hub.
Tap to turn the page.
You can receive notifications from Ajax, including alarms, device online/offline, arming mode change, relay switch, and system events(upgrade, time change, etc).
Check Devices
Tap a device to view its information.
Change Arming/Disarm Code
Switching arming mode requires entering the code. The default is 0000.
You can set a desired code. It will be synchronized to the indoor monitor’s built-in arming feature.
Log Out
Tap Settings to check the account information and log out.