1. Key Feature Overview
Applicable Scenarios: Only for commercial projects created after October 15, 2024
Repeat Modes: 2 options available (One-Time Runs take priority over Routine Schedules)
1. Routine Schedules: Repeats weekly
2. One-Time Runs: Repeats daily/weekly within a specified period
Permission: Accessible to installers, project managers, and administrators
2. Prerequisites
Compatible Device & Minimum Firmware Version
A08: 108.30.11.108 (higher versions are also supported)
3. Detailed Setup Steps
Mode 1: Routine Schedules (Weekly Repeat)
Take a project manager account as an example.
1. On the Doors module, click of the desired door.
2. To set up a routine schedule, click Edit on the Door Schedule section.
3. Select Hold Open door mode, which will be highlighted.
4. Hold and drag your mouse cursor to select a time block.
While setting up the schedule, you can:
- Click Copy from to copy a schedule from a configured door.
- Click Undo to withdraw the configuration.
- Click Clear to remove the configuration.
5. Click the block to adjust the time and enable Allow Manual Termination. This allows users to use their credentials to close the door.
6. [Optional]Apply the schedule to the whole week, weekdays, or weekends by clicking Copy to.
7. Save the setting and submit the schedule.
Mode 2: One-Time Runs (Repeat Within a Defined Period)
1. On the Doors module, click of the desired door.
2. Select One-Time Runs on the Door Schedules section.
3. Click +Add One-Time Runs.
4. Name the schedule.
5. Specify the schedule's effective time.
6. Select the Repeats mode: Daily or Weekly.
7. Select the Hold Open door mode, which will be highlighted.
8. Hold and drag your mouse cursor to select a time block.
9. Click the block to adjust the time and enable Allow Manual Termination. This allows users to use their credentials to close the door.
10. [Optional]Apply the schedule to the whole week, weekdays, or weekends by clicking Copy to.
11. Save the setting and submit the schedule.
The door automatically opens and remains open during the scheduled time.
With Allow Manual Termination enabled, when users use their credentials, the door will be closed.